Interpack TWA 1000-M, Operation Manual

Page: 16 / 60

TWA 1000-M (U9701) UDM 9701
16
S
ET
-U
P
P
ROCEDURES
W
ARNING
! T
HE KNIFE CONTAINED IN THIS
W
ATER
A
CTIVATED
T
APER IS EXTREMELY SHARP
. U
SE
CAUTION WHEN THREADING THE TAPE TO AVOID PERSONNEL INJURY
.
Filling the Water Bottle
1. Remove the water bottle by pulling it straight
up from the brush pot. ( See Figure 7-8)
2. Turn the bottle over so the water will not spill
3. Remove the rubber valve
4. Fill the bottle with warm water
5. Replace the valve
6. Reinstall the water bottle by inserting it over
the brush pot post and into the support
brackets located on the side of the taper
Figure 7-7
Brush Pot Assembly
The brush pot contains the moistening brush and the brush weight assembly. This unit must be removed
regularly to clean the moistening brush and brush pot of any accumulated adhesive buildup. Failure to
maintain a clean moistening brush will decrease the wicking action and result in poorly moistened water
activated tape.
Removing The Brush Pot
The brush pot should be removed and
cleaned regularly
1. Lift off the water bottle from the brush
pot stem as shown in Figure 7-8
2. Raise the front edge of the brush pot as
you slide it forward to remove it from the
cavity
Figure 7-8
Water Bottle
Lift Straight
Out
Water Bottle
Rubber Valve