Interpack ETII+ LD, User Manual

Page: 33 / 73

UH178TW / UH678TW UDH178-01
33
Knife Guard Spring Replacement
As a precaution, remove the cutter blade to
avoid injury
Figure 10-14
Removing The Cross Shaft
NOTE: These screws are secured with
Loctite and may require applied heat prior
to removal
1. Using two 2mm hexagonal keys as
shown, remove one of the flathead
countersink screws by applying
force on both hexagonal key in an
attempt to remove each screw.
2. Once one of the screws breaks fee,
only continue to remove that screw.
3. Leave the remaining flathead
countersink screw that did not yield
attached to the cross shaft
Figure 10-15
M5
BHCS
BLADE