Interpack ETII+ LD, User Manual

Page: 19 / 73

UH178TW / UH678TW UDH178-01
19
S
ET
-U
P
P
ROCEDURES
UUU
Tape Leg Length Adjustment
For optimum performance, the tape leg length has been factory set at 2 inches (50 mm).
However, the tape leg length can be modified.
Front Tape Leg
To adjust the tape leg length on the
leading end of the box, refer to
Figure 7-12 of the clutch assembly.
Facing the rear main frame, loosen
the two (2) Flat Head Cap Screws
using a 3 & 4 mm hexagonal key.
Rotate the clutch assembly to bring
the lowers screw towards the minus
(-) sign stamped on the rear plate for
a shorter tape leg. Conversely, bring
the bottom screw towards the plus
(+) sign for a longer tape leg.
Re-tighten both Flat Head Cap
Screws.
Figure 7-10
Rear Tape Leg
To adjust the tape leg length on the trailing
end of the box, both chrome knife arm
extension brackets must be re-positioned.
Unscrew the three (3) Flat Head Cap
Screws on each knife arm extension using
a 2.5 mm hexagonal key.
For a
UUU
Shorter Tape Leg
UUU
, bring the knife
arm towards the
UUU
front
UUU
of the tape head.
Conversely, for a
UUU
Longer Tape Leg
UUU
, bring
the knife arm towards the
UUU
rear
UUU
of the tape
head.
Replace the three (3) screws on each
knife arm extension and tighten.
Figure 7-11
Front
Rear
M6
M5
CLUTCH
ASSEMBLY
M4