16B Configure the network configurations:
The
Network Name / SSID
field defaults to “roving1”. This field contains a drop-down of all the wireless
networks visible to the ILT5000. You can either select from the list or enter a network SSID that is not on the
list (this may be the case where the network SSID is known, but that network is not currently visible to the
ILT5000).
Set the
Password / Security Key
field as appropriate. This field will be left blank if the network is operating
“in the clear”. The ILT5000 will automatically determine the appropriate security protocol (WEP, WPA, and
WPA2 are supported).
Set the
IP Address
. This can either be accomplished by:
a.
Using DHCP, which will automatically fill in the IP Address, Network Mask, and Gateway during
the configuration process.
b. Manually entering the IP Address, Network Mask, and Gateway
NOTE:
The DataLight II Software does not currently support automatic discovery of ILT5000’s. As a result, if
using DHCP will result in IP Addresses that change frequently (this is dependent on your network policy)
it is recommended that fixed/manual IP Addresses be used (check with your IT staff regarding policy for
manually setting IP addresses).
ILT5000 Research Radiometer Manual, Rev B, 4/17 10 of 13
