3C Side:
The right side of the meter includes:
A. USB A female port –
For firmware and system updates (requires a USB s"ck)
.
B. Micro USB female port –
For charging and extrac"on of saved data
.
C. Mini USB female port –
For charging the ba*ery & running external Datalight II so ware
.
D. Charging LED –
Light when device is charging (off when not charging)
E. On/Off – Fast Charge:
Turns meter on for use. Turn off to conserve ba*ery or for faster
charging.
3D. Top:
Contains the sensor mount, a
15-Pin D-Sub connector and
posts for securing the sensor to the device. The ILT2400 is backwards
compa"ble with all ILT1700 and ILT1350 “D” style sensors with the
excep"on of PMT's and SHD Low light level sensors. To connect the
sensor, align the sensor’s male 15 pin connector to the meter’s female
connector and apply slight pressure to insert. To assure proper connec"on is maintained during
tes"ng, "ghten screws on each side of sensor connector.
Note: The ILT2400 is also compa"ble with ILT1400 sensors, however in order to make the connec"on
a new connector or converter cable is required. Please contact
ilsales@intl-ligh+ech.com
to purchase
one of the following op"ons for using an ILT1400 L connector with the ILT2400:
1. “DCONXCHNGE” connector replacement (note: requires shipping sensor(s) to ILT),
2. A411-T converter cable (For Thermopiles sensors SEL623, SEL624 or SEL625 only)
3. A411 converter cable for all other sensors
(Note: A411 “L to D” converter cables come with approx. 6” of cable).
3E. Quick Se8ng Guide:
If your meter and sensor were purchased together along with op"cal
calibra"ons, your device(s) will arrive with factory pre-programmed op"cal calibra"on factors. (see
15D Manage Calibra"on Factors for self programming of calibra"on factors as needed)
1.Turn on the meter by pushing the On/Off bu*on down into the ( I ) posi"on.
2. A er a short start up menu the Home Screen will appear.
3. Connect the Sensor /Detector to the top of the meter and secure(See D above)
4. Check the power monitor window in the upper right hand corner to assure ba*eries have
enough charge to complete tes"ng. (see Sec"on 4 for charging instruc"ons)
5. Select your display style based on user preference (touch ICON to select)
Meter: Larger numerical values and no graph
Trend: Smaller control bu*ons with op"onal bar or line graph(see 15I for swap chart type)
Tall: Portrait mode (usb ports and on/off switch on the right)
Wide: Landscape mode (usb ports and on/off switch on the top)
6. To change the display style, use the home bu*on and touch the preferred display style icon.
7. The reading window will open in current mode and begin displaying measurements in amps.
ILT2400 INSTRUMENTATION MANUAL REV 1, 4/16
4 OF 19
代理美国International Light辐照计http://www.testeb.com/yiqi/ilt/zhaoduji.html 深圳市格信达科技 电话18823303057 QQ：2104028976
