InterMotive Inc.
12840 Earhart Avenue
Auburn, CA 95602
Phone: (530) 823-1048
Fax: (530) 823-1516
Page 3 of 6
www.intermotive.net
AFIS422VSX-B-021318-INS
Park Brake Fast Idle Trigger Enable/Disable
The AFIS422VSX-B is configured from the factory for Fast Idle
not
to be triggered when the Park
Brake is applied. If the Park Brake Fast Idle trigger is desired, it may be enabled (or disabled) by the
following procedure:
With key on, place the transmission in neutral, apply the Park Brake and press the Service Brake three times
within 5 seconds. Upon successful reprogramming, the on-board LEDs will briefly flash as a confirmation.
The user must cycle the key for the change to take affect.
A/C Fast Idle Trigger
The system is configured from the factory for Fast Idle to be triggered when the A/C clutch is engaged and
will stay engaged until the next key cycle, or a precondition is violated.
Fast Idle Pin-8 Trigger, Active: Ground or 12V signal Enable/Disable
The module is configured from the factory for an active ground fast idle trigger. To change this to an active
12V trigger:
Turn the key on, place the transmission in neutral, apply the Service Brake, pull out on the Park Brake,
release and apply the Park Brake four times within 5 seconds. Upon successful reprogramming, the LEDs
will flash as a confirmation. The user must cycle the key for the change to take affect. Repeat to reverse
back to a ground trigger.
