Page 39 of
85
4.2.12 Assembly – Oil Pump Housing (CRA-352)
Instructions
Cautionary Notes
1. Fit o-ring (ORN-7228) to bronze restrictor
(CR-3541)
2. Fit bronze restrictor into oil pump housing
3. Fit seal cover cap and torque to17 ft-lb.
4. Fit o-rings to sight glasses.
Apply grease to o-rings
5. Fit sight glasses; sight glass retainers and
o-rings.
6. Fit o-rings to oil pump housing.
Grease o-rings.
7. Fit oil pump drive gear drive pin into
crankshaft.
8. Slide the oil pump driver gear over the
crankshaft to line up with key.
This will be a firm slide fit.
9. Fit oil pump housing assembly.
Ensure that oil restrictor plate remains in
place when carrying out this process.
10. Fit retaining screws and tighten to correct
torque.
See Torque Setting Chart (section 3.4.4)
Intermech Ltd. BBR-6015-2 Compressor Service Manual
