MaxiScan 3010 - Installation Guide
7
1
Before you start
Introduction
The
MaxiScan 3010 Network
System is designed to connect a network of up to 20
MaxiScan 3100 and/or 3300 scanners. This Installation Guide explains how to
install your MaxiScan 3010 and how to set up a network configuration.
Use the EasySet System setup software to set up the MaxiScan 3010 Network
System. See section 5–
Setup
for more details.
In this Installation Guide, unless otherwise specified, “scanner” refers to the
MaxiScan 3100 and the MaxiScan 3300.
Warnings
Do not use a standard MaxiScan power supply connected directly to the
MaxiScan 3010 Network System if you have more than two scanners in your
network—use a power supply suitable for your operating requirements (see
the power calculation method in section 2-
Installation
).
Always use a grounded power supply.
Always use an adapter cable to connect a MaxiScan 3100 to the MaxiScan
3010. Never connect a MaxiScan 3100 directly to the MaxiScan 3010.
Maximum current accepted between the '+' and '–' of the SYNCHROS port is
50 mA max (higher current can damage the synchronization driver !).
Checklist of items for your installation
All Systems:
Y
MaxiScan 3010 Network System
Y
this MaxiScan 3010 Network System Installation Guide
Y
EasySet System setup software (on the CD ROM or can be downloaded from
the Intermec data capture web site:
http://datacapture.intermec.com
)
Y
RS-485 network cable(s)
Y
terminator connector
For part numbers
see Section 4 –
Accessories