Intermec CV60, Installation Manual, Page: 22 / 48

Chapter 2 — Installation Process
12 Vehicle Power Supply Installation Guide
Installation Recommendations
Review the lift vehicles to be serviced before you start. Plan the
installation following these safety and utility recommendations.
• Install the power cable at the vehicle power source if possible
or at the point where the connection is first made to the lift.
• Keep the power cable length as short as possible.
• Connect the negative lead to a point common to any other
electronic systems on the lift.
• Verify that the vehicle power source voltage falls within the
power supply input voltage rating. See
Chapter 1 “Power
Supply Options” for identifying information.
• Remember that the kit with the lower input (15-96 VDC)
voltage rating, P/N 851-041-003, has a 2-pin input
connector.
• Using a mounting bracket for the vehicle power supply
simplifies service, since you can take down and replace the
entire bracket with another bracket, and troubleshoot the
system away from the lift.
• Design a bracket that will be common to multiple lifts and
use pre-attached devices to simplify the device installation and
service.
Installation Summary
Carry out the primary installation steps in the order outlined
here. The sections that follow include detailed steps for each
segment of the vehicle power supply installation process.
To install the vehicle power supply
1 Connect the input cable to the power supply.
2 Mechanically install and secure the power supply.
3 Route and secure the power cable.
Warning: Equipment failure or damage will result
if the vehicle power source voltage does not fall
within the power supply input voltage rating.