Intermec 9189, User Manual

Page: 19 / 52

9189 RF Gateway
1-11
1
To configure the gateway
1. Set the DIP switches. For help, see “Understanding the DIP Switches” later
in this chapter.
2. Apply power through either the internal NiCad battery pack or the external
power supply. For help, see “Supplying Power for the Gateway” earlier in
this chapter.
3. Connect the data collection device. For help, see “Cables” earlier in this
chapter.
4. Make sure these parameters on the device match those configured for the
gateway:
•
Polling Mode D protocol
•
19200, 9600, 4800, or 2400 baud
5. Set the software parameters. For help, see “Setting the Software
Parameters” later in this chapter.
Note: If a TRAKKER 94XX is connected to the gateway using Polling Mode D, enable
the Check CTS option.
Setting the RF Channels
To set the RF Channels on the gateway you need to configure both the DIP
switches
and software. This procedure ensures that the unit will still access the
right channel if the gateway’s RAM is cleared.