Timer Power
Maintained Contactor
Operation Mode set to PUL.
ET8215 configured for contactor control.
L2/NEUTRAL
L1
Timer Power
Operation Mode set to SIM.
ET8215 configured for 240VAC DPST.
L2
L1
Load
AC IN
NO-1
NO-2
COM2
COM1
AC IN
NO-1
NO-2
COM2
COM1
COM
CLOSE
OPEN
Timer Power
Operation Mode set to PUL. ET8215 configured for bell ringing.
L2/Neutral
L1
Load
Timer Power
L2/Neutral
L1
L3
Load
1
Load
2
L5
L4/Neutral
L6/Neutral
AC IN
AC IN
NO-1
NO-2
COM2
COM1
Operation Mode set to IND. ET8215 configured for 2 X SPST.
NO-1
NO-2
COM2
COM1
Follow these instructions to install the time switch.
1. Open the time switch enclosure door.
2. Choose a knockout to remove from the enclosure.
NOTE: There are five 1/2 inch to 3/4 inch combination knockouts
available. There are two on the bottom of the enclosure, one on each
side, and one on the rear.
3. Insert a flathead screwdriver into the slot of a 1/2 inch knockout and
punch loose and remove.
NOTE: If a 3/4 inch knockout is needed, remove the 1/2 inch knockout
first, then the outer ring. Smooth edge if necessary.
4. Place the enclosure in the desired location, position at eye level, and
provide space for the enclosure door to swing open fully.
5. Drill the holes and then clean out each hole.
6. Insert plastic anchors into the holes, if needed.
IMPORTANT: If you are bringing power wires and wires for connecting applications through the back of the enclosure,
connect the wires before mounting the enclosure. Refer to the wiring diagrams in this manual.
7. Insert the top screw into the top hole and tighten. Hang enclosure.
8. Insert the remaining screws into the other holes and tighten.
9. Remove and retain the screw that secures the plastic insulator.
10. Lift the left side of the plastic insulator off the retaining post and pivot it away to expose the terminal strip.
NOTE: Do not remove the insulator.
11. Strip the supply and load wires to 1/2”.
Use AWG#10-#18 copper conductors rated at 90°C or better only.
12. Connect the wires to the proper terminals on the time switch connector and tighten the screws firmly.
See wire diagrams.
13. Return the insulator to its original position and replace the screw.
14. Close the enclosure door.
15. Apply power to the time switch.
Snap out catch
Tilt top forward
1/2 inch
