NX-1700E Card Reader
6
A
DDING
O
NE
U
SER
ACTION
RESULT
[
STAY
]
Accesses Activation mode
[
3-digit user number
]
Example:
if 4-digit user code
or
if 6-digit user codes
If a valid user number is entered, LED1 on any enabled readers
will begin to flash.
Scan the card designated for the user entered
in the previous step.
1) If the user card is not already in the system, it will be added
and mapped to the entered user number and LED1 will
flash.
2) If the card is already in the system, the reader will triple
beep and LED1 will continue flashing.
After about 30 seconds, all the readers in the system will
be updated with the new user card information.
A
DDING
M
ULTIPLE
U
SERS WITH
A
UTO
-I
NCREMENT
ACTION
RESULT
[
CANCEL
]
Use [NIGHT] on NX-1248E
Accesses Activation mode
[
3-digit user number
]
Example:
if 4-digit user code
or
if 6-digit user codes
If a valid user number is entered, LED1 on any enabled readers
will begin to flash.
Scan the card designated for the user entered
in the previous step.
1) If the user card is not already in the system, it will be added
and mapped to the entered user number and LED1 will
continue flashing indicating that the next user card can be
scanned for the next user number.
2) If the card is already in the system, the reader will triple
beep and LED1 will continue flashing; the user number is
not incremented in this case.
Continue scanning user cards until the desired
number of cards has been added.
After about 30 seconds without a card being scanned, all the
readers in the system will be updated with the new user card
information.
By default, user cards are added and activated. In order to add a user card and de-activate it at
the same time, scan and hold the card to be added until two beeps are sounded at the reader.
A
CTIVATE
O
NE
U
SER
(S
INGLE
U
SER
)
ACTION
RESULT
[
CHIME
]
not available on NX-1248E
Accesses Activation mode
[
3-digit user number
]
Example:
if 4-digit user code
or
if 6-digit user codes
If a valid user number is entered, LED1 on any enabled readers
will begin to flash.
Scan any card.
The card information for the user entered in the previous step
will be activated, and LED1 will stop flashing. After about 30
seconds, all the readers in the system will be updated.
