Concord 4 User Manual
35
3. Press B until the touchpad displays the light number you would like to
schedule.
See “Lights” on page 81 to determine which light number is associated with
which lamp.
4. Press #.
The touchpad displays the first available time schedule.
5. Press 2, # to assign the time schedule (on) for this light, or press 1, # to make
the time schedule inactive (off) for this light.
6. Press B to go to the next time schedule, or press *, 00, # to exit the
programming menus.
Sensor light control
Your security system can be programmed to turn on a selected light or lights
when sensors are activated. Each time the chosen sensor is activated, the
attached lights will turn on for 5 minutes. When 5 minutes have passed since the
last activation, the lights will turn off. For example, if you want house lights to turn
on when you open the front door, attach the desired lights to the front door
sensor.
Note:
If a light is attached to a sensor and a schedule, the light will only turn on
and off within the scheduled start and stop times.
To attach light to sensors:
1. Enter the programming menus by pressing 9,
system or partition master
code
.
2. Press 080.
The touchpad displays
LIGHT n TO SN x
, or
LT n SN x
(where
n
is the
light number and
x
is the sensor number).
3. Press A or B until the light number (1 to 9) you would like to activate appears.
4. Enter the sensor number (1 to 96 for Concord 4; 1 to 32 for Concord Express
V4) you wish to activate the light and press #.
5. Press B to assign another light to a sensor or press *, 00, # to exit the
programming menus.
To detach lights from sensors:
1. Enter the programming menus by pressing 9,
system or partition master
code
.
2. Press B until the touchpad displays
ATTACH LIGHTS TO SENSORS
or
LITE
TO SN
, then press #.
