![background image](http://html.mh-extra.com/html/interlogix/adc-is-300-lp/adc-is-300-lp_installation-manual_2076681005.webp)
RESETTING THE IMAGE SENSOR
There are two ways to reset the Image Sensor:
•
Power Cycle
– Power Cycle can be done by one of two ways: (1) Take out and reinsert batteries or (2) press and
release the sensor reset button. Only initiate a power cycle if the LED has not been active in the last 10 seconds.
After a power cycle, the Image Sensor will enter sensor power up state followed by the memory check state.
•
Network Reset
- An Image Sensor must be network reset when it has been previously enrolled on a different panel.
The Image Sensor will indicate that it is enrolled on a panel by blinking green after the memory check. In order to
perform a network reset, press and hold the reset button for a full 10 seconds or until the red LED flashes rapidly.
Release as sobon as you see the rapidly flashing red LED. A successful network reset will result in the LED blinking
https://answers.alarm.com/Installation_and_Troubleshooting/Image_Sensor/Interlogix_Simon_XTi_Image_Sensor/Interlogix_Simon_XTi_Image_Sensor_Installation_Guide_-_ADC-IS-300-LP
Updated: Tue, 17 Apr 2018 13:48:15 GMT
5