Remote Option 29 - Receiver 1 Poll Period
Note
: In UL listed systems, this option must be turned on and
SIA format must be used.
Default = 0000; Range = 4-digit, 0000, 0020-9999
This option sets the time between periodic link poll messages.
Link test messages are sent to the primary network receiver.
The poll period must be set less than the time set at the
receiver for link supervision failure. If the Poll Period is set to
0000, no polling is done.
Remote Option 30- Receiver 1 Port
Default = 9999; Range = 4-digit, 0000-9999
This option sets the TCP port number used to communicate
with the primary network receiver.
Remote Option 31 - Receiver 1 Format
Note
: In UL listed systems, this option must be turned on and
SIA format must be used.
Default = 0; Range = 0,1
Use this option to set the reporting format the Ethernet
Interface module will use when communicating with Receiver
1. Set to 0 for SIA, 1 for Contact ID. Simon Option 90
determines which reports are sent by Simon to the Ethernet
Interface module and eventually to Receiver 1.
Remote Option 32- Receiver 2 IP Address
Default = 000.000.000.000; Range = 12-digit, 4 octet
When the Ethernet Interface module has a TCP/IP connection
to a network receiver available this option should be
programmed with the IP address for the secondary receiver.
Leave the option set to 000.000.000.000 to disable
communication to the secondary network receiver.
Note
: When programming an IP address, 3 digits must be
used for each octet. An address of 10.1.8.100 would be
programmed at the panel as “010.001.008.100”. It is not
necessary to enter the periods.
Remote Option 33- Receiver 2 Number
Default = 0001; Range = 4-digit, 0000-9999
This option sets the Receiver Number the secondary network
receiver should use for this account.
Remote Option 34- Receiver 2 Poll Period
Note
: In UL listed systems, this option must be turned on and
SIA format must be used.
Default = 0000; Range = 4-digit, 0000, 0020-9999
This option sets the time between periodic link test messages.
Link test messages are sent to the secondary network
receiver. The poll period must be set less than the time set at
the receiver for link supervision failure. If the Poll Period is set
to 0000, no polling is done.
Remote Option 35- Receiver 2 Port
Default = 9999; Range = 4-digit, 0000-9999
This option sets the TCP port number used to communicate
with the secondary network receiver.
Remote Option 36- Receiver 2 Format
Note
: In UL listed systems, this option must be turned on and
SIA format must be used.
Default = 0; Range = 0,1
Use this option to set the reporting format the Ethernet
Interface module will use when communicating with Receiver
2. Set to 0 for SIA, 1 for Contact ID. Simon Option 91
determines which reports are sent by Simon to the Ethernet
Interface module and eventually to Receiver 2.
Remote Option 37- Ethernet Interface Module Software
Version
Default =; Range = -digit,
This option stores the software version of the Ethernet
Interface module.
Remote Option 38- Ping Page Directory Name
Default = Ping; Range = any
This option stores the Ping Page Directory Name.
Remote Option 39- Main Page Directory Name
Default = Gateway; Range = any
This option stores the Main Page Directory Name.
Remote Option 40- Registration Page Directory Name
Default = Gateway; Range = any
This option stores the Registration Page Directory Name.
Glossary
DHCP
Dynamic Host Configuration Protocol. A protocol that provides
a means to allocate IP addresses dynamically to computers on
a LAN. It eliminates the need to assign permanent IP
addresses manually. DHCP software runs on servers and can
10
Ethernet Interface Installation Instructions
