Figure 1
squeezing together the relevant support clips and re-locating in a new position.
Please ensure the clips are fully inserted and securely located prior to loading the
shelves. The clips should be mounted in such a way that the shelf is level. Failure to
This appliance is designed for a maximum of Climate Class 4. Please refer to the
ambient temperature and 55% relative humidity.
Do not place it next to a source of heat or humidity such as a glass or dish washer,
heater outlet, oven or any other potential heat or humidity emitting appliance or structure.
Do not place the appliance in direct sunlight.
Do not place near to a source of static electricity or where it is vulnerable to lightning strike.
The room must be well ventilated and free from sources of ignition. It must not be
located in a position where refrigerant could gather in the event of a leak. If it is below
ground level then extra precautions may be necessary and an expert should be consulted.
malfunctions may occur including, but not limited to, the condensate water not draining
away and the doors not functioning correctly. You may adjust the appliance using the
The appliance requires a minimum ventilation space at sides top and rear of 20mm.
The front grille must be completely unobstructed. See Figure 2.
Figure 2
accordance with all local laws and regulations. Safety Note: Please pay special
attention to the hazard represented by the plastic bag so that it may not be taken
by children.
Please take care not to pinch or damage the power cord in any way. Please examine
the power cord for any splits, cuts or damage.
The shelves may be adjusted by moving the clips as illustrated in Figure 1 below:
Warning: Do not exceed the maximum shelf loading weight of 25 kgs per shelf so as
to avoid injury or damage. Please ensure that the shelf support clips are securely
located in to the support strip for safe operations.The shelves may be adjusted by
do so could result in the shelf falling out of position and would be dangerous.
In Australia and New Zealand, the provisions of AS1677:2 1998 and subsequent amendments
must be adhered to.
more than 20mm
5
