Interflex Datensysteme GmbH
12/13
This table applies to a controller with 8 possible terminals on bus 1:
Old Address
Old HA
Controller
Command
Command
New Address
New HA
Bus
H
8
etp 8 -cx
344161
A
1
1
H
8
etp 8 -cx
344262
B
2
1
H
8
etp 8 -cx
344363
C
3
1
H
8
etp 8 -cx
344565
E
5
1
...
8
etp 8 -cx
...
..
...
...
A
1
etp 1 -cx
344868
H
8
1
A
9
etp 9 -cx
344262
B
2
2
6.3 Bridges on the I/O controller board
Check the setting of the bridges and adjust them, if necessary:
Br. 1:
When one I/O controller board is used, bridge 1 is always plugged in.
If a second I/O controller board is used, remove bridge 1 on the second I/O controller board.
Br. 2
: Bridge 2 is used to set the switching contacts of the NO/NC relay.
Br. 3
: Instead of bridge 3, an anti-tamper switch can be connected.
See also
Wiring Overview ........................................................................................................................ 8
7 Initial Operation
Once you have connected the IF-80x Outdoor terminal and set the address, lock it using the mortise
lock.
Additionally fasten the device with the included M2 x 6 mm countersunk head screw.
Switch on the power supply.
Configure the terminal in your host software, e.g. the IF-6040 system.
Make sure that your software recognizes and controls (online operation) the terminal.
Perform a booking at the terminal with a suitable credential.
Make sure that the booking reaches your host system where it is further processed.
For further diagnosis purposes, special programs and tools are available to system engineers and
consultants.
