Interchange CRN45-15, Operator'S Manual

Page: 10 / 20

15
o
Coil Roofing Nailer
Drives Coil Roofing Nails (¾" to 1¾" / 19 to 45mm)
Model No. CRN45-15
Item No. 65510
10
Interchange Brands Operator’s Manual
Operating the Nailer
NOTE:
The information contained in this Manual is designed to assist you in the safe
operation of the nailer . Some illustrations in this Manual may show details or attach-
ments that are different from those on your nailer .
Air Supply, Connections and Operating Pressure
Read section titled SAFETY. Make sure of the following before operation:
Air Supply
Power Source (Compressor)
„ Use only clean, dry, regulated compressed air as a power source for this
nailer .
„
NEVER use oxygen or other bottled gases, as an explosion may occur .
„ Air compressors used to supply compressed air to this nailer must comply
with the requirements of the latest version of ANSI Standard
B 19 .3 Safety Standard for Compressors for Process Industries .
„ Moisture or oil in the air compressor may accelerate wear and corrosion in
the nailer .
„ Drain daily .
Connections
1 .
Fittings
Install a female coupler to the hose . The female coupler will connect to the quick
release that fits the tool .
2 .
Filter-Regulator-Lubricator
„
NEVER connect nailer to pressure which potentially exceeds 150 psi .
„ Filter-regulator-lubricator units supply an optimum condition for the nailer
and extend the nailer life . These units should always be used .
Filter
„ The filter removes moisture and dirt mixed in compressed air .
„ Keep the filter clean by maintaining tool regularly .
„
Drain daily .
Regulator
„ The regulator controls the operating pressure for safe operation of the nailer .
„
Inspect the regulator before operation to be sure it operates properly .
Lubricator
„ The lubricator supplies an oil mist to the nailer .
„ Inspect the lubricator before operation to be sure the supply of lubricant is
adequate .
„ If an inline lubricator is not used, a few drops of oil will need to be added to
the air inlet before each use .