15
o
Coil Nailer
Drives Wire Collated Nails (2" to 3-9/16" / 50 to 90mm)
Model No. CN90-15
Item No. 65590
14
Interchange Brands
Operator’s Manual
Testing The Nailer
Before using the nailer, test it by using the check list below .
If abnormal tests occur, stop using the nailer and contact an authorized service center
immediately .
Conduct the test in the following order .
1 .
Adjust the air pressure to 70 psi and connect the air hose .
2 .
Without touching the trigger, depress the contact arm against the work piece . Pull
the trigger . ﹙The tool must fire the fastener .﹚
3 .
With the tool off the work piece, pull the trigger . Depress the contact arm
against the work piece . ﹙The tool must fire the fastener .﹚
4 .
Adjust the air pressure to the lowest setting possible according to the diameters
and length of fastener and the hardness of work piece .
WARNING!
■
Always follow the tool manufacturer’s safety and
maintenance instructions .
■
Always wear safety glasses with side shields when
operating or servicing tools .
■
Always disconnect the air supply from the tool and empty
the magazine when servicing tools .
!
■
Bump Fire (Multi-Fire)
Pull the trigger with the nailer
off the workpiece .
Depress the push lever against
the workpiece to drive a nail .
Move the nailer along the
workpiece with a bouncing
motion .
Each depression of the push
lever will drive a nail .
As soon as the desired number
of nails have been driven,
remove finger from the trigger .
Methods of Operation
Explanation of the nailing operation
Trigger
