3. Installation
—
Scape®
Lab
Technical specifications are subject
sla65-004
to change without notice.
Operating Manual
Version 1.6 – Status: 11/2019
Page 10 of 20
poc: SFi
3.
Installation
The
Scape®
Lab
is delivered ready for operation. All units are fully assembled and wired.
Place the device in a suitable location and connect it to the power supply.
3.1.
Notes
Observe the following points when setting up the device
:
·
Give the
Scape® Lab
sufficient time to adapt to the ambient temperature. Otherwise the device may be damaged or
destroyed by condensation inside the device.
·
Only operate the
Scape® Lab
indoors.
·
Do not expose the
Scape® Lab
to direct sunlight.
3.2.
Connection to the power supply
Connect the
Scape® Lab
to the mains supply using a suitable socket on the power distributor's power cord. Then set
the main switch on the centre bar to "I".
When disconnecting the appliance from the mains, always pull the plug and do not pull the cable.
Do not touch the plug with wet hands.
