vi. SI LA BORNE POSITIVE EST MISE A LA
MASSE, RACCORDER LA PINCE NEG
ATIVE
(NOIRE) DU CHARGEUR A LA BORNE
NEGATIVE (NEG, N, -) NON MISE A LA MASSE
DE BATTERIE. RACCORDER LA
PINCEPOSITIVE (ROUGE) AU CHASSIS DU
VEHICULE DU AU MOTEUR, LOIN DE LA
BATTERIE. NE PAS RACCORDER LA PINCE AU
CARBURATEUR, AUX CANALISATIONS
D'ESSENCE NI AUX PIECES DE LA
CARROSSERIE EN TOLE. RACCORDER A UNE
PIECE DU CADRE DU DU MOTEUR EN TOLE
DE FORTE EPAISSEUR.
vii. BRANCHER LE CORDON D'ALIMENTION
C.A. DU CHARGEUR.
viii. POUR INTERROMPRE L'ALIMENTATION DU
CHARGEUR, METTRE LES INTERRUPTEURS
HORS CIRCUIT, RETIRER LE CORDON C.A. DE
LA PRISE,ENLEVER LA PINCE RACCORDEE
AU CHASSIS ET EN DERNIER LIEU CELLE
RACCORDEE A LA BATTERIE.
m. L'UTILISATION D'UN ADAPTEUR EST
INTERDITE AU CANADA. SI UNE PRISE DE
COURANT AVEC MISE A LA TERRE N'EST PAS
DISPONIBLE EN FAIRE INSTALLER UNE PAR
UN ELECTRIEN QUALIFIE AVANT D'UTILISER
CET APPARIL.
—————————————————————
All 117 AC volt Interacter Professional and
Lineage Series chargers have an AC input fuse
located in the fuse drawer found below the AC
power cord. To access the fuse, you must
remove the power cord first and use a
screwdriver to open the fuse compartment. If
the fuse requires replacement, the same type
and value fuse must be used. The rating for the
fuse is found on the serial number label.
For units fitted with wall mounting brackets, the battery
charger should be securely attached to an indoor, dry,
vertical surface using four brass #8 X 1 round head
wood screws. (not supplied) The unit must be mounted
vertically with the wires at the bottom, in a location
where airflow for cooling is unobstructed for six inches
above and three inches to each side of the battery
charger.
MODEL EX 2402 evaluated to UL 1012
S
PECIAL "BTS" (Battery Type Switch) FEATURE
T
he Professional and I/C Series charger is fitted
with a Dealer settable BTS (Battery Type Switch).
The charging circuitry will work correctly with
Sealed, Gelled or Flooded type batteries.
Only an INTERACTER Authorized Service
Technician is authorized to change the charger
battery type setting. NOTE: Failure to select the
correct setting will affect the performance of the
battery, and may cause the battery to gas and
void any Warranty on the Battery. If Battery Type
is not specified the charger will be supplied set to
the "NORMAL" mode which will provide good
performance with most Battery Types and
applications.
The BTS is NOT intended for consumer use. If
your Dealer or Authorized Service Technician is
unable to offer you this Service, contact the
Factory for assistance.
The charger is Factory set in the "Normal Mode"
unless otherwise specified by the original
purchaser.
INTERACTER reserves the right to make
changes in it’s product without notice.
11
MOUNTING INSTRUCTIONS FOR
MODEL EX AND LS WALL MOUNT
CHARGERS