1.
Guide rails should be cleaned, and lubricant should be added onto the rail every two weeks.
2.
The materials for cleaning the rail: cotton cloth and lubricant oil
3.
How to clean the rail : push the laser head to one end of the rail ,and use the cotton cloth clean
the rail ,after that ,add some lubricant oil on the different part of the rail ,and then ,push the laser
head from one end of the rail to the opposite end, make sure the oil can be symmetrical added on
the rail .
4.
Tighten the screws and the shaft coupling
5.
After a period of the time, the screws and the shaft coupling maybe loose, and this will affect the
stability and mechanical movement of the machine. Tighten the screws and the shaft coupling
every two or three months to make the machine work normally.
6.
Bearing maintenance.
7.
Using the soft cloth to wipe the dust which on the bearing, and then use the oil suction needle
inject the oil into the bearing and slowly roll the bearing.
8.
Laser tube maintenance.
9.
The laser tube should avoid generating incrustation which would cause water stemming. If there is
incrustation, please clean it with 20% diluted hydrochloric acid.
10.
Light path
11.
The light path is made of reflecting by reflector and focusing by the focus lens. The focus lens
won‘t be skewing; but the skewing possibility of the three reflectors is high because of they are
fixed by mechanical part. So we advice customers make sure to check up the light part before
working.
WWW.INTERLASER.RU
35
