26
PS 9000 1U Series
© 2015 Intepro Systems, LP. Specifications subject to change without notice.
2.3.9 Connecting the analog interface
The 15-pole connector (Type: Sub-D, D-Sub) on the rearside is an analog interface. To connect this to a control-
ling hardware (PC, electronic circuit), a standard plug is necessary (not included in the scope of delivery). It is
generally advisable to switch the device completely off before connecting or disconnecting this connector, but at
least the DC output.
The analog interface is galvanically isolated from the device internally. Therefore do not
connect any ground of the analog interface (AGND) to the DC minus output as this will
cancel the galvanic isolation.
2.3.10 Connecting the USB port
To remotely control the device through this port, connect the device with a PC using the included USB cable and
switch the device on.
2.3.10.1 Driver installation (Windows)
On the initial connection with a PC the operating system will identify the device as new hardware and will install
the driver. The driver is a Communications Device Class (CDC) type and is usually integrated in current operating
systems such as Windows 7 or 10. But it is strongly recommended to use and install the included driver installer
(on the USB stick) to gain maximum compatibility of the device to our software.
2.3.10.2 Driver installation (Linux, MacOS)
We cannot provide drivers or installation instructions for these operating systems. A suitable driver may be found
by searching the Internet.
2.3.10.3 Alternative drivers
If the CDC drivers described above are not available on your system, or for some reason do not function correctly,
commercial suppliers can help. Search the Internet for suppliers using the keywords “cdc driver windows“ or “cdc
driver linux“ or “cdc driver macos“.
2.3.11 Initial commission
For the first start-up after purchasing and installing the device, the following procedures must be executed:
•
Confirm that the connection cables to be used are of a satisfactory cross section
•
Check that the default settings for set values, safety and monitoring functions and communication are suitable
for your application and change them where necessary, as described in the manual
•
If remote control thriugh a PC is active, read the additional documentation for interfaces and software
•
If remote control through the analog interface is active, read the section in this manual concerning analog in-
terfaces and, where needed, other appropriate documentation especially concerning the use of such interfaces
Summary of Contents for PS 9080-100 1U
Page 2: ......
