Intense Cycles TAZER, User Manual, Page: 15 / 17

2 8 // t a z e r u s e r m a n u a l I N T E N S E C Y C L E S // 2 9
Error indication type Indication condition Lighting pattern *1 Recovery
System error
Communication error with
the bicycle system Make sure that the cable is not loose or improperly connected. If the
situation does not improve, contact the place of purchase.
Temperature
protection
If the temperature exceeds
the guaranteed operating
range, the battery output
is turned off.
Leave the battery in a cool place away from direct sunlight until the
internal temperature of the battery decreases sufficiently. If the situation
does not improve, contact the place of purchase.
Security
authentication
error
This is displayed if a
genuine drive unit is not
connected.
This is displayed if
any of the cables are
disconnected.
Connect a genuine battery and drive unit.
Check the condition of the cables.
If the situation does not improve, contact the place of purchase.
Charging error
This is displayed if an error
occurs during charging.
Remove the charger from the battery and press the power button. If an
error appears contact an agency.
Battery malfunction
Electrical failure inside
the battery
Connect the charger to the battery and then remove the charger. Press
the power button with only the battery connected.
If an error appears with only the battery connected, contact the place of purchase.
*1 : No light : Lighting up : Blinking
Code Display preconditions Operational restriction when an error is being displayed Remedy
W010
Temperature of the drive unit
is higher than it is during times
of normal operation.
Power assistance may be lower than usual.
Stop using the assist function until the temperature of the
drive unit drops. If the situation does not improve, contact
the place of purchase.
W011
The traveling speed cannot be
detected.
The maximum speed up to which power
assistance is provided may be lower than
usual.
Check that the speed sensor is properly installed. If the
situation does not improve, contact the place of purchase.
W013
Initialization of torque
sensor was not completed
successfully.
Power assistance may be lower than usual.
With your foot off the pedal, press the battery power
button and turn on the power again. If the situation does
not improve, contact the place of purchase.
W032
An electronic derailleur may
have been installed in place of
a mechanical derailleur.
Power assistance provided in [WALK] mode
may be lower than usual.
The walk assist mode function may not be
able to be used in certain regions.
Reinstall the derailleur for which the system is configured
to support. If the situation does not improve, contact the
place of purchase.
W a r n i n g M e s s a g e s o n t h e C y c l e C o m p u t e r
This disappears if the error is fixed.
TROUBLESHOOTING //
B a t t e r y L E D L a m p E r r o r I n d i c a t i o n s
System errors and similar warnings are indicated by the battery LED lamps through various lighting patterns.
R e f e r e n c e //
Shimano Steps E8000 User Manual: http://si.shimano.com/pdfs/um/UM-72F0A-006-00-ENG.pdf