131 Eisenhower Lane North
Lombard, IL 60148
630.268.0010 / 1.800.251.2408
P/N 53-00920-100 Rev. B 101505
www.intellitec.com
Intellitec
INSTALLATION AND SERVICE MANUAL
Monoplex Trio
4
When the button is released at the desired output intensity setting, the value is stored and will be recalled
each time the output is enabled. If power is removed from the Monoplex Trio module and then restored, the
last known ‘dim value’ will be remembered and sotred internally in the module.
INSTALLATION
The module should be installed in a weather protected area with ventilation to prevent over-heating of the module.
There should be at least 3” around the module to provide adequate ventilation around the module.
It can be mounted with four #8 screws through the holes in the flanges. Twelve volt power should be brought to the
unit with a wire of sufficient size to safely feed all the loads.
If lighter loads are expected, smaller wire can be used. A suitable ring lug should be
crimped on the wire and then attached to the stud.
The loads are connected with a six pin Mate-N-Lok plug at J3. The Communications wires are part of the 2 by 3
MiniFit connector, J2. The module requires a power connection via a 1/4- 20 ring terminal connection at BP1. The
male Faston Terminal, J4, provides a maximum of 30 Amps to operate a motor control circuit.
choices
Since the maximum current is 60 amps, the minimum
wire size should be 6 gauge.
SWITCH PANELS AND SWITCHES ( Intellitec part number 00-00929-x00)
PROGRAMMING LINKS (Optional)
There are a number of switch panels
that can be used with the module. These include different styles and
back lighting options. In addition, conventional momentary switches can used, in conjunction with
, to activate any channel of the module.
To install the system, the number, style, and location of the switch panels and switches should be determined. Then
the number of wires (two for non-back lit and three for back lit) should be selected. The gauge for these wires will
depend on the number of switch panels and the total length from the furthest switch panel located within the vehicle.
The switch panel interface provides the ability for the user to select or activate the device shown on the face of the
panel. Diagnostic information will be displayed the switch panel as described previous to inform the user of the
status of the device operation.
In order to reset a faulted output, the user may press the switch again to turn it back on. If the fault condition has
cleared itself, then the output channel will resume operation. In the event that the fault is still present, you will need to
contact your repair service center for further instructions.
If a single switch in a given location is desired, a
can be wired in series with any
switch to activate that channel. (See Typical Wiring Diagram on the last page of this manual) There are six
Programming Links available for the system.
These links are color
coded to provide easy identification.
Channel
Color
Part No.
1
Brown
00-00963-100
2
Red
00-00963-200
3
Orange
00-00963-300
4
Yellow
00-00963-400
5
Green
00-00963-500
6
Blue
00-00963-600
Programming
Links
Programming Link
momentary
One is required for each switch function.
