131 Eisenhower Lane North
Lombard, IL 60148
630.268.0010 / 1.800.251.2408
P/N 53-00920-100 Rev. B 101505
www.intellitec.com
Intellitec
INSTALLATION AND SERVICE MANUAL
Monoplex Trio
3
1) the Switch Panel Backlit will illuminate if any of the switch panel buttons are depressed. This is a short
term activation of the backlit and the illumination will remain on for approximately ten seconds.
2) the Switch Panel Backlit will illuminate when the Parking Lights are enabled and will remain illuminated
as long as the Parking Light signal is present.
The fused power source for the Sofa Control is part of the Monoplex Trio module and provides intermittent
power up to 30 Amps for operation of the sofa settings. The operation of the Sofa Control is interrupted
when the Ignition signal is present at the Monoplex Trio module, refer to page 6 of this manual.
The TV Play Timer feature provides for the operation of the TV and the Audio system during a selectable
period of time (15 minutes to 30 minutes in 5 minute increments) when the Ignition is turned off. The TV
Play Timer will begin counting down whether the TV or Audio system is turned on prior to ignition being
removed. Once the Monoplex Trio TV Play Timer expires, cycle the ignition in order to reset the TV Play
Timer. The timer setting is selected by position 5 and 6 of SW1, Dip Switch located on the Monoplex Trio
module, (see page 6 for specifics).
There are four output channels that may be configured to dim. The channels that are dimmable are output
channels 1,2,3, and 4. The configuration to make any or all of the four output channels dimmable is
outlined for the Dip Switch, SW1, in the table below:
1
ON
Output 1 J3-1
2
ON
Output 2, J3-2
3
ON
Output 3, J3-3
4
ON
Output 4, J3-4
The Dip Switch settings are read on initial power up of the Monoplex Trio module and if changes are made
to the Dip Switch settings, it recommended that power to the module be removed and restored to have the
latest changes incorporated. The initial factory default setting for each of the output channels is 100%. All
DIP switches are initially set to the OFF position for SW1.
To program the output dim setting for a selected channel, requires that you press and hold the selected
switch for a period of three seconds in order to enable the dimming sequence. If the output has been
programmed previously, it will begin at the saved output setting.
If the output is at the factory default, then the output will decrease approximately 10% every second until
the button is released. If the button is held until the last step is reached, 10% output intensity, the output
will then increase 10% per step until the it reaches the maximum output intensity of 100%.
Sofa Control
TV Play Timer
Dimmer Operation and Setup
Position
Enable Dim
Channel
