20
4
、
Network Connection
4.1
、
Connecting Mode
1)
Direct connection:
Connect the camera and computer by network connecting cable.
2)
Internet connection mode:
Connect the camera to Internet by Router or Switch and user can log in the device by
browser.
Note:
Please do not put the power and network cable in places where can be easily touched to prevent video quality
lowered by unstable signal transmission due to poor contact of cables.
The computer must have the network segment where the camera IP address belong to. The device will not be
accessible if without the segment. I.E. The camera default IP address is 192.168.5.163, then segment 5 must be added
in the computer. Specific steps are as below:
Pic 4.1.1 Local Network Setting
a)
Firstly open the window of Local Area Connection Properties on computer, select the “Internet protocol version
4(TCP/IPv4)” as shown by pic 4.1.
b)
Double click or click the property “Internet” protocol version 4 (TCP/IPv4)to enter into the Internet Protocol Version
4(TCP/IPv4) Properties window, and select “Advanced” option as shown Pic 4.1.1
c)
Select “Advanced” to enter into the Advanced TCP/IP Setting and add IP and subnet mask in the IP browser as picture
4.1.2, Click the “Confirm” to finish the adding of IP segment. User can add the corresponding network segment according
to the revised IP address of the camera.
