3
switch to the “PC” side. If after connecting the Ethernet cable from the unit to your
network/system and the LAN link light does not turn on, move the switch to the alternate
position.
Note:
Turn the NAS off then turn it back on to get an IP address from the network.
Ethernet Port
The Ethernet port is used to connect to a PC, server, hub,
switch or other network device on the LAN.
Reset Button
If you forget your password and/or unit IP address, you will not
be able to access the NAS. You can use the Reset Button to
restore the factory settings. To initiate a reset, you must hold the
button for at least 5 seconds or until the unit stop beeping.
The primary default settings are listed in the following table.
Configuration Item
Default Settings
Administrator Username
<empty>
Administrator Password
admin
Internal IP address
Dynamically Assigned (DHCP Client)
Power Button
Turns the unit on/off. Press lightly once. The unit will write
all data into the drive and safely power down. To force the
unit to power down immediately, press and hold the
button until the power is off.
