Intelligent Home Cronus, Installation And User Manual

Page: 17 / 22

-13-
Setting Codes Tables
Toggle one of the DIP
switches and it will trigger Address Setting page to come on screen.
There are two way to set the Address/User Code: via DIP switches on the rear of monitors or
via Address Setting page
Entering Address Setting Page
INSTALLER SETUP
_
SW+ SW
- RING GND NC
1 2 3 4 5 6
ON
DIPS
L1
L2
01.00
Master
Code Setting Item Code Setting Item
2412 Reset To Default Setting 8016-8017 Bypass Enable/Disable
2499 Restore Factory Settings 8401-8499 Unlock Time
8000 Master Monitor 8018-8020 Video Display Standard
8001~8003 Slave Monitor 9015-9016 Enable/Disable Intercom Call
8006-8007 Setting Slave Monitor Panel On/Off 9017-9018 Sc reen Ratio 4:3/16:9
8010-8011 Unlock Mode:Close/Open
S
elect
DIP S witcher S et A ddre ss
setting, then touch icon, total 32
User C
odes will
be displayed
Power Saving Mode On/Off
By default the system is set to Power Saving Mode, where only the first Monitor in the system
comes On with video when Door Station called. All other Monitors will ring but without video.
Video will be transferred to the Monitor which answers the doorbell call.
To switch the power saving mode Off: (so all Monitors ring with video) tick ‘Slave Panel On’ on
the ‘Address Setting’ page or type in code 8006 # on ‘Installer Setup’ page