SKYPLAY-DFS Installation Guide
20
•
The receiver keeps outputting a “Searching…” message, and the NETWORK LED constantly blinks
It should take up to one minute to establish a wireless link. If the link was not established within that time period,
verify the transmitter is powered on and not connected to another receiver.
•
The receiver is outputting “Connected to source name, Please Check Video Source”
Check the HDMI connection between the transmitter and the video source.
•
The receiver displayed a connection failure message and outputs a “Wireless Off” message
If there is more than one registered transmitter, and the receiver failed to connect to it within a minute or two, the
receiver will go into standby mode and shut down the wireless radios. In order to connect to the desired source, press
the
Source
button on the IR remote and choose the desired source.
•
The Link LED blinks rapidly and there is no video on the display
Power cycle the SKYPLAY-DFS-R. If the issue remains, the device might be faulty. Please contact Liberty AV Solutions
technical support.
•
Link cannot be established or poor video/audio quality
Try to decrease the range between the transmitter and the receiver or remove obstacles out of the way between the
transmitter and receiver.
Other Issues
