Installation
To install the Intelix AVO-A4-WP110-EU balun, perform the following steps:
1.
Turn off power and disconnect the audio equipment by following the manufacturer’s
instructions.
2.
Make certain that outlets and cross connects to which you will connect the AVO-
A4-WP110-EU are configured properly and labeled correctly to identify the point-
to-point circuit.
3.
Verify the desired twisted pairs are not being used for
other LAN or telephony equipment.
4.
Prepare the balun housing by removing the optional
extension wings. Snap the wing along the break line.
5.
Connect the AVO-A4-WP110-EU to a twisted pair cable,
such as Cat 5 or Cat 6. Verify the pinout on the balun
conforms to EIA/TIA 568B standards, as labeled on the
balun.
6.
Mount the AVO-A4-WP110-EU in a wallbox.
7.
Connect a second compatible Intelix balun to the opposite end of the twisted pair
cable. Verify the pinout on the balun conforms to EIA/TIA 568B standards.
8.
Connect the RCA outputs from the source equipment to the first AVO-A4-WP110-
EU.
9.
Connect the RCA inputs from the receive input to the second compatible Intelix
balun.
10.
Power on the source and destination equipment and test for correct operation.
Caution:
Do not attempt to disassemble or alter the balun housing. There are no
user-serviceable parts inside the unit. Doing so will void your warranty.
Caution:
Do not connect the balun to a telecommunication outlet wired to
unrelated equipment. Doing so may damage the unit or any connected equipment.
Ensure all connected twisted pair cabling is straight-through (point-to-point).
Caution:
When connecting twisted pair cables to the 110 punch-down connector
on the balun, care should be taken to keep the wires twisted as close to connector
as possible. This will help eliminate stray EMF interference.
Caution:
Do not strip the jacket from the individual wires in the twisted pair
cable. The 110 punch-down connector will strip the wire jacket during
termination. Stripping the jacket may result in shorts.
