18
»
IP Version:
the camera operates with both IP protocols,
IPv4, as shown in TCP/IP Version 4 image, and IPv6, as shown
in the following image.
TCP/IP - version 6
»
IP address:
in
Static mode you can set the desired IP.
Attention:
it is necessary to check an available IP on the network to avoid conflict between two devices.
»
Subnet Mask:
field to configure the subnet mask of the device, when in
Static mode. This field will only appear when
IPv4 is enabled.
»
Local Link:
local IPv6 address for camera access. Each device has its own local link. To access the camera using this
address, simply be on the same network as the camera. This option appears only when
IP version - IPv6 is selected.
»
Gateway:
field to set the gateway of the device, when in
Static mode.
»
Primary DNS:
field to configure the IP address of a
DNS server.
»
Secondary DNS:
field to configure the IP address of a
DNS server. This is the alternate server that will be used when
the Primary DNS is inaccessible.
»
Simultaneous Connections:
defines the maximum number of simultaneous connections to the camera’s web
interface. The maximum allowed is 20 connections. For video stream access, for example: via web interface, iSIC, RTSP,
etc., the maximum allowed is 4 independent video streams.
»
TCP port:
the default value is
37777. It can be changed to values between 1,025 and 65,535.
»
UDP port:
the default value is
37778. It can be changed to values between 1,025 and 65,535.
»
HTTP Port:
the default value is
80. It can be changed to other values if necessary.
»
HTTPs Port:
port used to access the IP camera via HTTP over an additional security layer. At this layer, data is transmitted,
encrypted and the authenticity of the camera is verified using digital certificates. The default value is
443. It can be
changed to values between 1,025 and 65,535.
Note:
To change the HTTPs port, you must disable the HTTPs service so that you are then allowed to change the
port.
»
RTSP port:
the default value is 554, but it can be changed.
Note:
to access the camera’s video stream through software, you can use the camera’s RTSP path, which is
:
»
For the Main Stream
rtsp://USER:PASSWORD@IP:PORT/cam/realmonitor?channel=1&subtype=0
»
For the Extra Stream
rtsp://USER:PASSWORD@IP:PORT/cam/realmonitor?channel=1&subtype=1
