10
GND SINC +12V
ALARME
D3
S1
J4
J5
J6
Canais de Frequência
Sincronismo
Níveis de Potência
Bornes
Chave Tamper
PCI
Tamper
Jumper Relé
Buzzer
NF NA
O
FF
O
N
BUZ
ZE
R
Jumper
RX
J1
J2
J3
C
M L
LED - Alinhamento e Disparo
Tamper switch
Power Levels
Frequency channels
Tamper
Terminals
Relay Jumper
Jumper
Buzzer
Synchronism
PCI
Receiver (RX)
LED - alignment and trigger
2
It is necessary to remove the receiver board to access the Configuration Jumper and disable the Buzzer.
Follow the steps below to perform this configuration:
1. Pull the base of the aluminum tube;
2. Remove the board and the Buzzer Jumper (Jumper J6);
3. Place the board back into the aluminum tube while observing the groove and then fit the base of the aluminum tube.
BU
ZZER
ON
OF
F
R10
R5
R50
R9 R1
R3
J6
B1
K1
Q4
Jumper Buzzer (J6)
Base Tubo
de Alumínio
Canaleta
de encaixe
da placa
Canaleta
de encaixe
da placa
Tubo de
alumínio
1
2
3
Aluminium
tube
Aluminium
tube
Buzzer Jumper (J6)
Plate
plug-in
channel
1
2
3
Plate
plug-in
channel
4. With the sensors properly configured, secure the transmitter and receiver so that they are vertically and horizontally
aligned. Install the cable entry side facing down. Always install the sensors in a position where the largest number of
beams will be interrupted;
Parede ou suporte
Conexão dos fios
Parede ou suporte
Conexão dos fios
5. Pass the cable through the protection indicated below to connect it to the terminal block;
