9
Transmitter
J1
Frequency channels
With Jumper - Frequency Channel A - (Factory default)
Without Jumper - Frequency Channel B
J3
Tamper
With Jumper - Tamper disabled (Factory default)
Without Jumper - Tamper enabled
J4
Power
1
'
Jumper in L Position - High Power (Factory default)
Jumper in Position M - Medium Power
Jumper in Position C - Low Power
Without Jumper - minimum power (indicated for short distances and with reflection)
1
It is recommended to use the power jumper always at the highest power (L), this ensures a greater intensity of the infrared signal.
GND SINC +12V
D12
S2
J4
Canais de Frequência
Tamper
Níveis de Potência
Bornes
Chave Tamper
PCI
TX
J1
J3
C
M L
LED - Alinhamento e Disparo
Tamper switch.
Power Levels
Frequency channels
Tamper
Terminals
PCI
Transmitter (TX)
LED - alignment and trigger
RECEPTOR
C
M
L
J1
J2
J3
J4
P
adrã
o de
fa
bri
ca
Factory Default
J4
Receiver
Receiver
J1
Frequency channels
With Jumper - Frequency Channel A - (Factory default)
Without Jumper - Frequency Channel B
J2
Synchronism
With jumper - No sync cable is required (Factory default)
No jumper - Sync cable required
J3
Tamper
With Jumper - Tamper disabled (Factory default)
Without Jumper - Tamper enabled
J4
Power
1
'
Jumper in L Position - High Power (Factory default)
Jumper in Position M - Medium Power
Jumper in Position C - Low Power
Without Jumper - minimum power (indicated for short distances and with reflection)
J5
Relay logic
NF
Normally closed relay (factory default)
NA
Normally Open
J6
Buzzer2
With jumper - Buzzer enabled (Factory default)
No jumper - Buzzer disabled
1
It is recommended to use the power jumper always at the highest power (L), this ensures a greater intensity of the infrared signal.
