Hardware Installation and User’s Guide
19
Hardware Installation
2.2.3
Beep Sequences During System Boot
During system POST, the audible alarm on the controller will produce one of a number of
beep sequences to indicate the status of the controller. See
for a description of
these beep sequences.
Table 2-3. Beep Sequences
Beep Sequence
Status
beep - pause - beep,
beep, beep
Controller startup was successful.
beep, beep, beep, beep,
....
RAID controller has a problem. A possible cause is disk failure. To
diagnose the problem, run the Storage Console to check the status of
the RAID controller and array.
beep, beep - pause -
beep, beep - pause - ....
Memory or firmware may have a problem. More details may be
available from the boot message. If necessary, recover the firmware by
following the procedure in
Appendix A, “Flash Memory Programming”
.
Summary of Contents for SRCS14L - RAID Controller
Page 12: ......
