Intel SRCS14L - RAID Controller, Hardware Installation And User'S Manual

Page: 15 / 31

Hardware Installation and User’s Guide 15
Hardware Installation
Figure 2-2. Installing the IIR Controller into a Computer System
2.1.3 Changing Jumper Settings
The IIR controller normally comes ready to be installed into the computer motherboard
immediately. However, jumper settings are available to:
•
Reprogram the RAID firmware that is located in the flash memory of the IIR controller.
•
Set the PCI bus speed (force 33 MHz or auto-negotiate 33/66 MHz).
The board contains 2 jumper blocks to control the functions described in Table 2-1 . See
Figure 2-3 for jumper locations and pin numbers, and see Appendix A for a detailed
description of jumper J1.
PCI