Intel SR1695GPRX, Service Manual

Page: 69 / 174

Riser Connector
Riser Card
Add-in Card
AF003372
A
C
B
Intel
®
Server System SR1695GPRX Service Guide 49
6. Pull the add-in card from the socket in the riser assembly. You may need to wriggle
the card from front to back to remove it, but use caution so you do not twist or bend
the card. See letter “B” in Figure 32.
7. Install a filler panel over the opening at the rear of the riser assembly. See letter “C”
in Figure 32.
8. Re-install the screw you removed in Step 5. See letter “A” in Figure 32.
Figure 32. Removing a Full Height Add-In Card
Note: Make sure that all empty add-in card slots have filler panels installed.
9. Install the PCIe* Riser assembly into the server system. For instructions, see
“Installing a PCIe* Riser Card” .
10. Install the processor air duct. For instructions, see “Installing the Processor Air
Duct” .
11. Install the server system cover. For instructions, see “Installing the Server System
Cover” .
12. Plug all peripheral devices and the AC power cable into the server.