Intel SR1695GPRX, Service Manual

Page: 51 / 174

Air Duct
EP0007
Intel
®
Server System SR1695GPRX Service Guide 31
Installing the Processor Air Duct
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” .
2. Power down the server and unplug all peripheral devices and the power cable.
3. Remove the server system cover. For instructions, see “Removing the Server
System Cover” .
4. Lower the air duct into place, insert the two hooks at the front of the processor air
duct into the corresponding slots on the bracket behind the two system blower fans.
Use caution not to pinch or disengage cables that may be near or under the air duct.
5. Install the server system cover. For instructions, see “Installing the Server System
Cover” .
Figure 14. Installing the Processor Air Duct
Installing and Removing Memory
Caution: The memory is NOT hot-swappable. Before removing or replacing any memory DIMM,
you must first take the server out of service, turn off all peripheral devices connected to
the system, turn off the system by pressing the power button, and unplug the AC power
cord from the system or wall outlet.
The silkscreen on the board for the DIMMs displays DIMM A1, DIMM A2, DIMM B1,
and DIMM B2 starting from the center of the board. See
“Memory” for a discussion of the
memory requirements and options. See “Server System References” for a link to the list of
tested DIMMs.