Intel SR1695GPRX, Service Manual

Page: 68 / 174

Riser Connector
Riser Card
Add-in Card
AF003371
A
B
C
48 Intel
®
Server System SR1695GPRX Service Guide
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see “Removing the Server
System Cover” .
4. Remove the PCIe* Riser assembly. For instructions, see “Replacing a PCIe* Riser
Card” .
5. Remove the screw at the rear of the riser assembly. See letter “A” in Figure 31 .
Save this screw. You will reinstall it later.
6. If a filler panel is installed over the opening at the rear of the riser assembly, lift it
from the riser assembly. See letter “B” in Figure 31. Save the filler panel in case
you later need to remove the add-in card.
7. Insert the add-in card into the socket in the riser assembly. Push the add-in card into
place firmly until it seats in the riser card connector, but use caution so you do not
twist or bend the card. See letter “C” in Figure 31.
8. Re-install the screw you removed in Step 5. See letter “A” in Figure 31.
Figure 31. Installing an Add-In Card
9. Install the PCIe* Riser assembly into the server system. For instructions, see
“Installing a PCIe* Riser Card” .
10. Install the server system cover. For instructions, see “Installing the Server System
Cover” .
11. Plug all peripheral devices and the AC power cable into the server.
Removing a PCI Add-in Card
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” .
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see “Removing the Server
System Cover” .
4. Remove the PCIe* Riser assembly. For instructions, see “Replacing a PCIe* Riser
Card” .
5. Remove the screw at the rear of the riser assembly. See letter “A” in Figure 32 .
Save this screw. You will use it later.