Local Control Panel Kit Installation Instructions
Local Control Panel Kit Install Guide
3
Remove Bezel Assembly
Release the two plastic tabs (see letter “A” in the following figure) on the left side of the
bezel assembly to disengage the tabs. Rotate the bezel assembly (see letter “B”) no more
than 40 degrees outward. At a 40-degree angle, push the bezel assembly away from the
chassis (see letter “C”). If the bezel assembly does not immediately disconnect from the
chassis then tap the left-hand side of the bezel assembly to disengage the bezel hooks on
the right-hand side of the chassis.
Caution: Do not rotate the bezel assembly more than 40 degrees or you can damage the bezel hooks
on the right-hand side of the bezel assembly.
Figure 2. Removing Bezel Assembly
TP01042
B
C
A
A
