Intel® Server Board M10JNP2SB User Guide
26
Figure 14. Front panel USB 3.0 connector
5.5
Onboard SATA Support
The server board includes an AHCI SATA controller embedded in the chipset, providing eight 6 Gb/sec SATA
ports with the following functionality:
•
Two white single port 9-
pin connectors labeled “SATADOM
-1/SATA-0
” and “SATADOM
-2/SATA-1
”
,
providing support for SATA DOM (Disk on Module) storage devices.
•
Six SATA ports on the server board labele
d “SATA
2-7
”
5.5.1
SATADOM support
The 9-pin connectors labeled
“SATA
-0/SATADOM-
1” and “SATA
-1/SATADOM-
2”
support SATADOM devices
and provide two additional pins to power a connected device. Figure 15 shows the pinout for the connectors.
PIN
1
2
3
4
5
6
7
P1
P2
Signal
GND TXP TXN GND RXN RXP GND VCC 5V GND
Figure 15. SATADOM connector pinout
Note
: The ports are located close to the front edge of the server board. Refer to the documentation of the
chassis where the server board will be installed for details on clearance at the front edge of the board to
determine the dimensions of the SATADOM devices that can be installed.
Summary of Contents for M10JNP2SB
Page 2: ... Blank page ...
Page 15: ...Intel Server Board M10JNP2SB User Guide 15 Figure 4 Component height restrictions ...
Page 16: ...Intel Server Board M10JNP2SB User Guide 16 Figure 5 Major components and connectors 1 of 2 ...
Page 17: ...Intel Server Board M10JNP2SB User Guide 17 Figure 6 Major components and connectors 2 of 2 ...