Intel GD82559ER, Datasheet

Page: 13 / 94

Datasheet 7
Networking Silicon —GD82559ER
3. Signal Descriptions
3.1 Signal Type Definitions
3.2 PCI Bus Interface Signals
3.2.1 Address and Data Signals
Type Name Description
IN Input The input pin is a standard input only signal.
OUT Output
The output pin is a Totem Pole Output pin and is a standard
active driver.
T/S Tri-State The tri-state pin is a bidirectional, input/output pin.
S/T/S Sustained Tri-State
The sustained tri-state pin is an active low tri-state signal owned
and driven by one agent at a time. The agent asserting the S/T/
S pin low must drive it high at least one clock cycle before
floating the pin. A new agent can only assert an S/T/S signal low
one clock cycle after it has been tri-stated by the previous
owner.
O/D Open Drain
The open drain pin allows multiple devices to share this signal
as a wired-OR.
A/I Analog Input The analog input pin is used for analog input signals.
A/O Analog Output The analog output pin is used for analog output signals.
B Bias The bias pin is an input bias.
Symbol Type Name and Function
AD[31:0] T/S
Address and Data. The address and data lines are multiplexed on
the same PCI pins. A bus transaction consists of an address phase
followed by one or more data phases. During the address phase, the
address and data lines contain the 32-bit physical address. For I/O,
this is a byte address; for configuration and memory, it is a Dword
address. The 82559ER uses little-endian byte ordering (in other
words, AD[31:24] contain the most significant byte and AD[7:0]
contain the least significant byte). During the data phases, the address
and data lines contain data.
C/BE[3:0]# T/S
Command and Byte Enable. The bus command and byte enable
signals are multiplexed on the same PCI pins. During the address
phase, the C/BE# lines define the bus command. During the data
phase, the C/BE# lines are used as Byte Enables. The Byte Enables
are valid for the entire data phase and determine which byte lanes
carry meaningful data.
PAR T/S
Parity. Parity is even across AD[31:0] and C/BE[3:0]# lines. It is stable
and valid one clock after the address phase. For data phases, PAR is
stable and valid one clock after either IRDY# is asserted on a write
transaction or TRDY# is asserted on a read transaction.Once PAR is
valid, it remains valid until one clock after the completion of the current
data phase. The master drives PAR for address and write data
phases; and the target, for read data phases.