Monthly Specification Update
Enterprise Platforms and Services Marketing
v
26.
Failures seen installing to a SATA drive when SATA is set to “Legacy” in the BIOS
setup
14
27.
System hangs after disabling on-board video in the BIOS setup .......................... 14
28.
The SMBIOS entry point may not be visible under certain hardware configurations14
29.
Intel® Embedded Server RAID Technology II and I/O module IRQ routing conflict15
30.
SuSE* Linux Enterprise Server may not install successfully with Intel® Embedded
Server RAID Technology II enabled ....................................................................................... 15
31.
Red Hat* Enterprise Linux 4 and BIOS setup display a different L2 cache size for
the Quad-Core Intel® Xeon® processor 5300 Series ............................................................. 16
32.
Change Logo Utility causes BIOS corruption ........................................................ 16
33.
Microsoft Windows System Event Viewer* may record Error Event with ID 11 ..... 16
34.
After the system reboots, the POST screen may generate "NMI has been received
- System Halted" message ..................................................................................................... 17
35.
Intel® RAID Web Console 2 utility displays “Unexpected Sensor” warning
message in Microsoft Windows* operating system ................................................................ 17
36.
Random drives may go offline when a sixth drive is installed and Intel® Embedded
Server RAID Technology II is enabled in the Intel® Server System SR2500ALBRP .............. 18
37.
Intel recommends enterprise-class hard drives for use with Intel® Server Systems18
38.
Dual Gigabit Expansion Module may not properly reset ....................................... 18
39.
SAS drive in a ROMB RAID 5 may drop offline during a reboot in the Intel® Server
System SR2500PALLX .......................................................................................................... 19
40.
Intel® Server System SR2500ALLX sixth hard drive filler panel is difficult to
remove
19
41.
SuSE* Linux Enterprise Server unable to boot after basic installation .................. 20
42.
Drives may not be detected or may go offline in the Intel® Server System
SR2500ALBRP when operating at SATA 3GB/s data rate ..................................................... 20
43.
New versions of BMC firmware with previous versions of BIOS cause system
POST failure .......................................................................................................................... 21
44.
Intel® Server System SR2500ALLX may operate louder than expected .............. 21
45.
Red Hat* Enterprise Linux may report the wrong processor speed ....................... 21
46.
The SuSE* Linux Enterprise Server 10 driver for SAS HW RAID causes unwanted
error logs during installation ................................................................................................... 21
47.
IERR or thermal trip event reported in System Event Log (SEL) after system power
on
22
48.
USB device generates “The following boot-start or system-start driver(s) failed to
load: i8042prt" error message in Microsoft Windows* operating systems ............................... 23
49.
Microsoft Windows* and Intel® RAID Web Console II report an error when the
ASR2500SATAPE kit is used ................................................................................................. 23
50.
System may log IERRs when running certain Red Hat* Enterprise Linux versions
on the Intel® Server Board S5000PAL with video driver ati_drv.o 6.5.6 ................................. 23
51.
Microsoft Windows* operating systems installed without a service pack will display
blue screen with BIOS 79 and 81 ........................................................................................... 24
52.
Sluggish system performance may be experienced with BMC 60......................... 25