January 2007
219
Intel
®
855GME Chipset and Intel
®
6300ESB ICH Embedded Platform Design Guide
Intel
®
6300ESB Design Guidelines
Note:
When designing front panel I/O in a system where a connector card will be used ensure that there
aren’t duplicate EMI/ESD/thermistor components. Duplicate components will result in drop/droop
and signal quality degradation or failure.
9.6.6.3.1
Front Panel Daughter Card Design Guidelines
1. Place the V
BUS
bypass capacitance, CMC, and ESD suppression components on the daughter
card as close as possible to the connector pins.
2. Follow the same layout, routing and impedance control guidelines as specified for
motherboards.
3. Minimize the trace length on the front panel connector card. Trace length less than two inches
is recommended.
4. Use the same mating connector pin-out as outlined for the motherboard in
“Front Panel Connector Card” on page 218
5. Use the same routing guidelines as described in
Section 9.6.1, “Layout Guidelines” on
.
6. Trace length guidelines are given in
and
9.7
Low Pin Count (LPC) Interface.
The 6300ESB implements a Low Pin Count (LPC) Interface compliant with the Low Pin Count
Interface Specification
Revision 1.0. The following section provides design guidelines for proper
interfacing with the LPC bus. These guidelines will help to minimize signal integrity issues and
maintain conformance to LPC specifications.
The LPC Interface to the 6300ESB is shown in
. Note that the 6300ESB implements all
of the signals that are shown as optional, but peripherals are not required to do so. For the
6300ESB:
•
LSMI# may be connected to any of the 6300ESB’s GPIO signals, as they may be configured
as inputs to generate an SMI#.
•
The Super I/O’s PME# may be connected to the PCI PME# signal, however this may cause
software problems. A better choice is to connect it to one of the 6300ESB’s GPIO signals, as
they may configured to generate an SCI.
•
The 6300ESB’s SUS_STAT# signal is connected directly to the LPCPD# signal.
Figure 113.
Motherboard Front Panel USB Support
B1165-01
Motherboard
Front Panel USB Ports
Summary of Contents for 6300ESB ICH
