-4-
6. LET THE FUN BEGIN!
After reading all of the above information, you are likely ready to
start racing!
Just proceed as follows:
A. Fully extend the antenna on your transmitter.
B. Turn your transmitter on.
C. Turn your vehicle on.
D. Adjust the “ThrottleTrim” knob on your transmitter if necessary(if the wheels are moving forward
without touching the trigger, turn the throttle trim counter clockwise untill the wheels stop.)
L
5. To change frequency crystals simply remove the black plastic crystal
holder from the back of your transmitter by carefully pulling it straight
out. Slide the crystal out of the holder and install the new crystal labeled
“ Tx”in its place. Then carefully align the two pins that extend from
the transmitter, and gently press it into place.
Do not force the crystal! The pins can easily be broken! Remove the
crystal from your receiver in the same careful manner using a pair of
needle-nose pliers and install the new “Rx”crystal in its place.
PLEASE NOTE:
It is very important that the crystal labeled “ Tx” is installed in the
transmitter and the crystal marked “ Rx”is installed in the receiver.
PLEASE NOTE:
If you do not have any “reverse” when pusing the trigger forward twice , adjust the throttle trim further in
the counter clockwise direction. If you pull the trigger all the way back to forward full speed and your car
stops, then adjust the throttle trim in the clockwise direction. But becareful not to go too far or your
vehicle may not be able to reach full speed when pulling the trigger all the way back.
E. Adjust the “Steering Trim” knob on your transmitter if necessary (so your car will travel in a straigth
line without turning the steering wheel)
F. By now you are likely kicking up dust or burning up the asphalt. We highly recommend that you
continue readding the reminder of this manual to find out how you can get even more enjoyment
out of your vehicle.
RUNNING MULTIPLE VEHICLE
If you have some vehicles that would like to get a vehicle of their own or already have friends with
other vehicles that you will be racing, it is very important that you first check what frequency channe
your vehicle is on and confirm that none of your friends have the same frequency as yours. If you do
find that someone else is using the same frequency channel that you are, you must wait for them to
turn their transmitter and vehicle OFF or you may choose to change the frequency crystals in your
transmitter and receiver (so that you can run together at the same time without causing any radio
interference). Additional frequency cystal sets can be purchased separately and installed in a few
quick seconds.
