15
Rear panel facilities
12V TRIGGER A, B terminals
These terminals are provided so that you can use the operation of
the DTR-7.1 control the operation of another externally connected
device. Connect the component to this 1/8-inch mini-jack terminal
and when the set input source is selected, the device will turn on.
Set the 12V TRIGGER terminal using the 12V Trigger setting of
the 12V Trigger sub-menu (see page 40).
ZONE 2
These are the audio output jacks for the remote zone (Zone 2). Use
these outputs to connect the remote zone. For the connection
procedure, refer to “Connecting to the remote zone (Zone 2) input”
on page 24. These outputs are activated by the Zone 2 button on
the front panel.
AC INLET
Plug the supplied power cord into this AC INLET and then into the
power outlet on the wall.
• Do not use a power cord other than the one supplied with the
DTR-7.1. The power cord supplied is designed for use with the
DTR-7.1 and should not be used with any other adevice.
• Never have the power cord disconnected from the DTR-7.1
while the other end is plugged into the wall outlet. Doing so
may cause an electric shock. Always connect by plugging into
the wall outlet last and disconnect by unplugging from the wall
outlet first.
Composite
video jack
S video jack
VIDEO IN/OUT
These are the video inputs and outputs. On the rear panel, there are
4 video inputs and 2 video outputs and each one includes both
composite video and S video configurations. Connect VCRs, LD
players, DVD players, and other video components to the video
inputs.
The 2 video output channels can be used to be connected to video
tape recorders for making recordings.
• When connecting a VCR or other video component, make sure
you connect the audio and video leads together (i.e., both to
VIDEO 3).
• The VIDEO 4 inputs are located on the front panel.
RS 232
The RS 232 port is to be used in conjunction with an external
controller to control the operation of the DTR-7.1 by using an
external device.
AC INLET
Power cord
(supplied)
To an AC
wall outlet
