31
En
Listening to the Radio
With the built-in tuner you can enjoy AM and FM radio
stations. You can store your favorite stations as presets for
quick selection.
This model changes frequency steps (
).
Listening to the Radio
Tuning into Radio Stations
■
Auto tuning mode
When tuned into a station, the
TUNED
indicator lights.
When tuned into a stereo FM station, the
FM STEREO
indicator lights on the display, as shown.
■
Manual tuning mode
In manual tuning mode, FM stations will be in mono.
Tuning into weak FM stereo stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
manual tuning mode and listen to the station in mono.
■
Tuning into stations by frequency
You can tune into AM and FM stations directly by enter-
ing the appropriate frequency.
This section describes the procedure using the but-
tons on the front panel unless otherwise specified.
Using the Tuner
Press
Tuner
to select either “AM” or “FM”.
In this example, FM has been selected.
Each time you press
Tuner
, the radio band changes
between AM and FM.
(Actual display depends on the country.)
1
Press
Tuning Mode
so that the AUTO indicator
lights on the display.
2
Press
Tuning
q
/
w
.
Searching stops when a station is found.
Band
Frequency
TUNED
FM STEREO
AUTO
1
Press
Tuning Mode
so that the AUTO indicator
goes off on the display.
2
Press and hold
Tuning
q
/
w
.
The frequency stops changing when you release the
button.
Press the buttons repeatedly to change the frequency
one step at a time.
1
On the remote controller, press
Tuner
repeatedly
to select “AM” or “FM”, followed by
D.TUN
.
(Actual display depends on the country.)
2
Within 8 seconds, use the number buttons to enter
the frequency of the radio station.
For example, to tune to 87.50 (FM), press
8
,
7
,
5
,
0
.
If you have entered the wrong number, you can retry
after 8 seconds.