11
EN
FUNCTIONAL OVERVIEW
Installing the Batteries in the Remote Control
Install the batteries (AAx2) matching the polarity
indicated inside battery compartment of the remote
control.
1
Open the cover.
2
Insert batteries.
Make sure to match + and - on the batteries to the
marks indicated in the battery compartment.
3
Close the cover.
Note
Incorrect use of batteries can result in hazards such as
leakage and bursting. Please observe the following:
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
Although they may look similar, different batteries
may have different voltages.
• Make sure that the + and - ends of each battery
match the indications in the battery compartment.
• Remove batteries from battery compartment that is
not going to be used for a month or more.
• When disposing of used batteries, please comply with
governmental regulations or environmental public
instruction’s rules that apply in your country or area.
• Do not recharge, short-circuit, heat, burn or
disassemble batteries.
Using a Remote Control
Keep in mind the following when using the remote
control:
• Make sure that there are no obstacles between the
remote control and the infrared sensor window on the
unit.
• Remote operation may become unreliable if strong
sunlight or fluorescent light is shining on the infrared
sensor window of the unit.
• Remote control for different devices can interfere with
each other. Avoid using remote control for other device
located close to the unit.
• Replace the batteries when you notice a fall off in the
operating range of the remote control.
• The maximum operable ranges from the unit are as
follows.
30˚
30˚
Appro
x.
16 ft.
(5 m)
Remote control sensor
DBS-30.1
Infrared sensor window
E5K55UD̲DBS-30.1̲EN̲v1.indd 11
E5K55UD̲DBS-30.1̲EN̲v1.indd 11
2009/05/15 11:43:41
2009/05/15 11:43:41
Summary of Contents for DBS-30.1
Page 1: ...DBS 30 1...
Page 57: ...57 EN MEMO...
Page 58: ...58 EN MEMO...
Page 59: ...59 EN MEMO...
