intarblock | intartop
23
In case of accident due to refrigerant inhalation follow the following instructions:
§
Move the victim where it could breathe fresh air. The victim should lay on its back or its shoulder.
§
Call emergency services if needed.
In case of eye injures due to refrigerant splatters:
§
Never rub the eyes. In case contact lenses are used, you must take them out.
§
Eyes should be kept open and washed with plenty of water.
§
The victim should be taken to an emergency medical service
In case of burn due to contact with the skin
§
Wash with plenty of running water the affected part and take out the clothes while water is applied
on.
§
Never cover the affected parts with cloth, bandages or oil.
21. INSTALLATION AND MOUNTING
The final emplacement of the unit will affect the good performance of the unit. For an optimal
performance, please follow the following recommendations:
§
During the reception of your unit, please verify that it is free from any transport damage. Otherwise
indicate the perceived damages on the receipt.
§
Install the unit in a room with good ventilation and away from heat sources.
§
Keep clean the surroundings of the unit to facilitate the air intake and exhaust, and make sure the
air does not reflow.
INTARBLOCK units are designed for wall mounting directly onto the cold room panel. To do so, cut
out the indicated frame on the wall panel, depending on the type of mounting.
§
Drop mounting (except series 0).-
1. Before assembling the cold room, cut out the corresponding frame for the unit structure and
drill the hole for the drain pipe in the specified position.
2. Remove the drain pipe from the drain tray. To do so screw out the side cover of the inner part
and release the end of the tube.
3. Place the unit before assembling the roof of the cold room.
4. Place the drain pipe through the hole in the panel. Then, replace the roof panel.
