© Intatec Ltd 2017
23
Installation
3. The supply to which the thermostatic shower valve is to be installed must be thoroughly
flushed and cleaned to remove any debris, which may have accumulated during the
installation. Failure to remove any debris will affect the performance and the manufacturer’s
warranty of the product. In areas that are subject to aggressive water, provision must be
made to treat the supplies prior to the supplies entering the shower valve.
4. The thermostatic shower valve has been designed for horizontal installation and surface
mounting.
5. The thermostatic shower valve will be installed in such a position that maintenance of it’s
components, associated valves and the commissioning and testing of the shower valve can
be undertaken.
6. The hot and cold water supplies must be connected to the valve strictly in accordance with
the indications on the body of the valve i.e. hot water supply to the hot port of the valve.
7. In a situation where one or both of the water supplies are excessive, it is recommended to fit
a Pressure Reducing Valve to reduce the pressure(s) to within the limits as quoted previously.
8. Any thermostatic shower valve must be fitted with a back flow prevention device, such as
check valves to prevent the cross contamination of supplies. The thermostatic shower valve
is supplied complete with integral insert check valves and strainers.
9. Isolation valves in an accessible position are required as close as is practicable to the water
supply inlets of the thermostatic shower valve.
10. The fitting of strainers is recommended as close as is practicable to the water supply inlets of
the thermostatic shower valve.
11. It is essential that the fail safe thermostatic shower valve should not be installed in situations
where there is a possibility of the valve being deprived of water or where demands for
water are greater than the actual stored supplies.
12. To ensure that the performance levels of the thermostatic shower valve are maintained (in
the event of cold water failure), the temperature of the hot water supply at the point of entry
to the thermostatic shower valve must be a minimum of 10˚C above the commissioned
mixed water discharge temperature.
13. The fail-safe thermostatic shower valve must not be subject to any extreme temperature
variations either during the installation or under normal operating conditions.
Summary of Contents for Kiko DELUXE KIKOD20
Page 27: ...Intatec Ltd 2017 26 Notes...
Page 28: ...Intatec Ltd 2017 27 Notes...
Page 29: ...Intatec Ltd 2017 28 Notes...
